Product Range
Thermoseal Group
Enquiry List
0845 331 3950
Back to full range of machinery

1.6M 4-Brush Deluxe (for 3-12mm glass)

This open top glass washer has a production speed of up to 5m/min which gives it the facility to produce around 2,000 sealed units/week.  It is supplied with a 1.4m automatic entry rack and 2.0m automatic exit rack with light inspection panel.

It can process pieces of glass bigger than 1.6m on the shortest edge by simply putting them through the washing cycle twice.

The simple to use control centre for the machine is fixed at working height by the out-feed rack and is possible to access all electrical trips from this point as well as perform the day-to-day operation of cleaning glass. 

Product CodeSW6005
Height1600mm (62.992 inches)
Width5700mm (224.409 inches)
Weight900kg (1984.16 lbs)
Guide PriceOn Request
Thermoseal Group
Thermoseal Group
Thermoseal Group
  • Specs
  • Parts & Service


Cleaning of the glass is facilitated by rotating brushes and high pressure water jets.  When in high speed mode, the fine bristles on the brushes creates a very efficient scrubbing action.  Standard brushes fitted are suitable for coated glass and normal float glass.

After the wash cycle, glass is sprayed with a high pressure water rinse and then rubber wiper blades pull off any excess water.  Glass is then dried by a sound insulated high speed fan which forces air through narrow ducts.  These warm columns of air remove any remaining water from the surface of the glass leaving it ready for inspection when it feeds onto the illuminated outfeed rack.

Product Codes:
SW005 left to right
SW006 Right to Left

Additional dimensions
Total Height:  2250mm
Total Length:  5700mm
Infeed Rack:  1600mm x 1400mm
Outfeed Rack:  1600mm x 2000mm

Construction and Finish 
Construction:  Hard wearing steel
Areas in contact with water:  stainless steel.
All other areas:  painted steel.
Top Seal:  Rubber gasket (open top)

Glass Specification
Maximum Glass Height:  3200mm
Minimum Glass Size:  300 x 100mm
Glass Thickness:  3 - 12mm

No. of brushes:  4
Brush Type:  Low E standard
Brushes driven by:  Chain mechanism
Washing area (Hot): Two wash and one rinse
Washer speed:  5m/min
Internal rollers:  Soft type fitted as standard
Dryer:  Fan encased in sound proof box.

Water Requirements 3/4 inch tap (garden type)
Drainage Requirements 1 1/2 inch plastic drain
Voltage Requirements 400V 3-phase + N + E
Frequency Requirements 9.2kW

Parts & Services

All new Glass Washers are sold with a warranty as follows: 

UK mainland Warranty: 

12 months parts and labour warranty, including delivery and installation.

Export Warranty:

12 months parts warranty.  Delivery and installation by quotation.